Collection

A standard 8' long square edge form (single piece of SE-001 or SE-002) that is factory cut to accommodate a radius as tight as 6".

CRTE Mold Release works very well with concrete and materials used to build molds such as melamine coated particle board, polyester and most urethane liquid rubber and liquid plastic products.

For a full bullnose edge

NR.2 BaseColor is an ultra fine pigment (dye) used to create a coloured concrete.

For a bullnose edge

For a modern edge

Combo Pack CRTE Diamond polishing pads grit 100 (coarse), 200 (middle) and 400 (fine). For use with polishing machine. High quality polishing pads for wet and dry use.

Complete set of StoneTech Diamond hand polishing pads. 100,200 and 400 grit.

CRTE NR.5 Super White Portland Cement. An 8 kg bag of high quality white cement.

One reusable silicone faucet knockout that will create a 1-3/8" hole which will work with most standard faucets. It will also create a 2-1/2" pocket that is 1" beneath the surface to fasten hardware in.

This package contains twelve 8 foot pieces (96 lineal feet) of reusable Pre-Cast forms, approximately 4 mm thick x 2 " x 1.5". Use these forms to create a mold and cast your countertop off site

Reusable, 8 foot concrete form liner made to fit perfectly inside of Z Counterforms. Gives a realistic, rock face edge to your counter.