Edges

A standard 8' long square edge form (single piece of SE-001 or SE-002) that is factory cut to accommodate a radius as tight as 6".

Finally a concrete countertop form that is meant for heavy duty commercial bar tops and islands. Instead of the standard 2-1/4" tall appearance from our regular forms

Double Fancy Radius - 57mm

https://www.concretecountertopsolutions.com/articles/videos

One reusable silicone faucet knockout that will create a 1-1/4" hole which will work with most standard faucets. It is meant to be used with our thinner EuroForm ONLY and 1/4" substrate.

For a full bullnose edge

For a bullnose edge

Reusable, 8 foot concrete form liner made to fit perfectly inside of Z Counterforms. Gives a realistic, chiseled slate edge to your counter.

For a modern edge

For an ogee edge

Provides superior holding power to hold sink form firmly in place or can also be used on either side of our Pre-Cast Form to hold the form to the pouring surface. This tape has a polyester backing making it paper thin.

This package contains twelve 8 foot pieces (96 lineal feet) of reusable Pre-Cast forms, approximately 4 mm thick x 2 " x 1.5". Use these forms to create a mold and cast your countertop off site